Weeks 10-12
Skip to content
Leslie and Mikhael with the frame
Kate and Mun working on the electrical system
Caitlin and Max with Noel discussing wheels and handlebars
Caitlin with her wheels
Mikhael working on the frame
Max with the top end and its newly found gasket
The various engine groups around the table
Max and Caitlin with the wheels
Mark with the primary cover and his software
Mun greeting Mikhael and Jamie who recently returned from painting
Devon preparing to apply gasket to the plate in between the transmission and timing side cover
Kate busy with the electrical system
Mark working on his gaskets
Francesco and Max looking for parts
Max and John working on the top end
Mikhael deep cleaning some parts
Jamie’s newly painted fender
Max and Francesco trying to assemble the forks
Phil looking for a part
Colby with the top end
Max and Colby trying to figure out a screw issue with the top end
Working on the forks
Mikhael cleaning part of the frame
Kate working away
Top end missing two important plugs
Jon, Max, and Colby planning their next move with the Top End
Glenn and Mun working on the frame
Max, Francesco, and Glenn working on the frame
Mary Kate searching for a whitworth wrench to use on the bottom end
Members of the Bottom End and Top End groups around the engine table
Mark with his first printed gaskets
Max and Francesco continuing work on the forks
Mikhael and Francesco working on the Frame while Mary Kate and Sydney talk with Professor Littman in the background
Mun and Kate working on the electrical system
Mark with the laser printer software
Al with the laser printer
Al redistributing the weights to hold down the roll of gasket material
The laser printer at work
The freshly printed gasket
Caitlin and Kate consulting a manual with the frame
Caitlin, Max and Francesco continuing work on the forks
Max poised to enter the engine into the frame
Mark, Max S. and Max B. working on putting the engine into place.
Continuation of placing the engine
Mikhael and Caitlin with the front wheel
Everyone else watching on as the bike is not large enough for all seventeen of us
Continuation of placing the engine
Max and Mark eyeing an issue on the engine
Devon excited to install the clutch
Caitlin working on the front wheel while Jamie adjusts the battery box and Max focuses on the rear wheel
Max and Phil looking at the chain on the rear wheel
Jamie trying to figure out his next move
Kate hooking up the wires surrounding the battery box
Caitlin and Mikhael looking at the front wheel while Leslie inspects the bottom end
Sydney, Mark and Leslie working on the bottom end
Max S observing Max B working while Jamie and Phil work on the rear wheel
Max doing a bit of work with the carburetor
Max and Phil working away on the hooking up the rear wheel to the output sprocket on the transmission
Sydney and Mark attempting to shorten a cable with a pocket knife
Mun and Mark working away
Devon installing the clutch while Max watches
Mun preparing to work on the electrical system
Phil, Glenn, Max and Noel working on the rear wheel
Devon tightening the nut on the clutch
Francesco and Caitlin happy with their forks and front wheel
Inside of the timing side in a lull when no one was working on it
Devon installing the rotor
Sydney, Mun, and Phil discussing the electrical system
Max drying a bit of tubing
Phil working on attaching the clutch cable to the lever
Noel and Mark observing Al using the lathe
Mikhael with some of his painted frame parts